How To Install Corrugated Metal Roofing Over Shingles. Labor cost to install metal roof. For the second row, start with a half shingle and then work your way to the other side of the roof.
Align the first metal roofing panel so that it overlaps the edging by 1/2 to 3/4 of an inch and is square to the roof line. This is what it looks like when you install a steel shingle roof system over an existing asphalt shingle roof. Installing metal roofing panels over shingles.
Table of Contents
Alternatively, A Metal Shingles Roof Can Be Installed Over The Old Asphalt Shingles, If You Do Not Want To Tear It Off, Provided There Is Only One Layer Of Existing Shingles On The Roof.
Make sure that the sheets cover the whole roof area. Start at one eave and work your way up, overlapping the panels as you go. Cut panels to size as needed using a circular saw with a compatible blade.
Labor Cost To Install Metal Roof.
Make sure that each sheet overlaps the first one. Align the first metal roofing panel so that it overlaps the edging by 1/2 to 3/4 of an inch and is square to the roof line. Because asphalt shingles are routinely exposed 5 in., rip down the first strip (the starter course) so that it is 5 in.
Because Metal Roofs Are So Light Yet So Strong, Metal Roofing Panels Can Typically Be Easily Installed Over Your Existing Asphalt Roof Shingles Without The.
You can install that new corrugated metal sheets over your old shingles, provided that your local roofing codes allow it. Fasten the panels with metal roofing screws according to manufacturer instructions. There are a number of considerations when installing metal panels over an existing asphalt shingle roof.
Steadily Work Your Way Up Towards The Roof Ridge.
You can also drastically reduce the labor cost since you can cover more square feet with a single corrugated panel than you. Begin installation of panels at the bottom of the roof along the eaves. As you place the upper panel over the panel below, overlap by 1 inch.
Attach Your Metal Sheets To The Framing.
Make sure the upper ends of the shingles at the upper course slide under the uninterrupted course of shingles above. Fasten the shingles in place with roofing nails at each shingle. Leave the old valley flashing in place, and install new over it.